Observer Matrix : Matrix CLI : Matrix CLI : system log snmp enable
   
system log snmp enable
The system log snmp enable command turns on the ability to send system log events as SNMP traps.
By default, sending of SNMP traps is disabled and must be explicitly enabled. This command is one of four used to configure sending SNMP traps of log information. The other three are: system log snmp severity , system log snmp host , and system log snmp community .
System logs remain accessible through the dashboard and CLI interfaces.
You must use system log restart to save your changes. Use show log settings to check settings before making any changes.
 
Usage
system log snmp enable
 
 
Examples
matrix_host# system log snmp enable