Observer Matrix : Matrix CLI : Matrix CLI : show log settings
   
show log settings
The show log settings command lists current log settings.
Use show log settings to see SysLog and SNMP settings, such as whether logging is enabled, the severity threshold, host name, port, and community string.
For reference, these are the severity thresholds show log settings and example log events.
Parameter
Description
info
Informational messages. They can be queried for trends. No action is required.
Example: New network settings have been applied
warn
Warning messages. They indicate a potential issue. An error might occur if corrective action is not taken in a given time.
Example: Error reading general config file
error
Error messages. They indicate non-urgent failures. These indicate changes or events that did not match expected results, such as a file could not be opened or program was busy. Typically, these are critical messages and must be addressed by changing some input value before the desired result is achieved or by your device administrator or developer.
Example: Unable to open CLI config file. No such file or directory
fatal
Fatal message. These messages indicate an imminent issue that should be corrected immediately, such as during updating the firmware or resetting the system defaults. Contact your support staff.
Example: Unable to apply firmware update!
 
Usage
show log settings
 
 
Examples
matrix_host> show log settings